Urodynamic tests check the function of the bladder and help to investigate the cause or urinary incontinence. Note: the information below is a general guide only. The arrangements, and the way tests are performed, may vary between different hospitals. Always follow the instructions given by your doctor or local hospital.
What are urodynamic tests?
Urodynamic tests help doctors assess the function of your bladder and the urethra (bladder outflow tract). They are usually done to investigate urinary incontinence in women.
During the tests, your bladder is filled and then emptied while pressure readings are taken from the bladder and the abdomen (tummy). The idea is to replicate your symptoms, then examine them and determine their cause.
What are urodynamic tests used for?
Urodynamic tests are used to help diagnose:
- Stress urinary incontinence.
- Urge urinary incontinence.
- Mixed incontinence (stress and urge urinary incontinence).
They may also be helpful in investigating other causes of incontinence. Urodynamic tests are particularly important if surgery is being considered for the problem, to make sure the correct operation is performed.
Understanding urine and the bladder
The kidneys make urine all the time. A trickle of urine is constantly passing to the bladder down the ureters (the tubes from the kidneys to the bladder). You make different amounts of urine depending on how much you drink, eat and sweat.
The bladder is made of muscle and stores the urine. It expands like a balloon as it fills with urine. The outlet for urine (the urethra) is normally kept closed. This is helped by the muscles beneath the bladder that sweep around the urethra (the pelvic floor muscles).
When a certain amount of urine is in the bladder, you become aware that the bladder is getting full. When you go to the toilet to pass urine, the bladder muscle contracts (squeezes), and the urethra and pelvic floor muscles relax.
Complex nerve messages are sent between the brain, the bladder, and the pelvic floor muscles. These tell you how full your bladder is, and tell the right muscles to contract or relax at the right time.
Urodynamic tests can help doctors assess which type of incontinence you have. The treatment that you receive will differ depending on the type of incontinence you have.
There are a number of different causes of incontinence including the following:
- Stress incontinence is the most common type. It occurs when the pressure in the bladder becomes too great for the bladder outlet to withstand. It usually occurs because the pelvic floor muscles which support the bladder outlet are weakened. Urine tends to leak most when you cough, laugh, or when you exercise (such as when you jump or run). In these situations there is a sudden extra pressure (stress) inside the abdomen and on the bladder.
- Urge incontinence (unstable or overactive bladder) is the second most common cause. This is when you get an urgent desire to pass urine. Sometimes urine leaks before you have time to get to the toilet. The bladder muscle contracts too early and the normal control is reduced.
- Mixed incontinence. Some people have a combination of stress and urge incontinence.
For more information on incontinence see separate leaflet called 'Urinary Incontinence'.
How do urodynamic tests work?
The first part of the test checks how much urine leaves the bladder over a certain length of time. This is called the flow rate. A special toilet records the flow of your urine. A computer then checks for any abnormalities in flow rate.
A decreased flow rate can indicate problems with bladder emptying. For example, this could be an obstruction to bladder drainage or underactivity of the bladder muscle.
The second part of the test is called filling cystometry. For this test, thin tubes called catheters are inserted into the bladder and the rectum or the vagina. These can measure the pressure in the bladder and abdomen as the bladder fills with fluid. Using these measurements doctors compare the different pressure readings.
If urine leaks with no change in pressure in the bladder muscle, you may have stress incontinence. Leaking is provoked by an increase in pressure inside the abdomen - for example, when coughing.
If involuntary bladder muscle activity causes an increase of pressure in the bladder and leads to leaking, you may have urge incontinence.
What happens during a urodynamic test?
The test is done in a room in the X-ray department.
For the first part of the test, you will need to empty your bladder into a special toilet called a flowmeter. This measures how much urine you pass and the flow of the urine. You will usually be left alone in the room whilst you are doing this. This is why you need to come to the test with a full bladder.
The next part of the test measures the way your bladder works as it fills up. You will be asked to lie down on a special bed. Two catheters (very fine tubes) are put into your bladder, by inserting them into your urethra. You may find this a little uncomfortable. One is to fill up your bladder and the other to measure the pressure in your bladder. Another fine tube is put into your vagina or rectum (back passage). This allows the pressure inside your bladder to be compared with the pressure outside your bladder.
Once the catheters are in the correct position, fluid runs into your bladder at a controlled rate. This slowly fills your bladder whilst recordings are made. The doctor or nurse performing the test will ask you questions - for example, how your bladder feels and when it feels full.
Once your bladder is full, the bed will move and stand you upright. You may be asked to cough and some X-rays of your bladder are taken.
If you leak urine when you cough, try not to feel embarrassed. If you leak at home when you cough, it is best for the test operator to see you leak during the test. It is important to remember that it is helpful to see how your bladder behaves on a day-to-day basis to make sure that the correct treatment is provided.
You will then be asked to empty your bladder into the special toilet again at the end of the test, with the catheters still in place.
What should I do to prepare for a urodynamic test?
Your hospital may ask you to arrive for your test with a comfortably full bladder. If this is difficult some hospitals may ask you to arrive a little early so that you can have a drink to fill your bladder.
What can I expect after a urodynamic test?
After the tests some people feel a slight stinging or burning sensation when they pass urine. If you drink plenty of fluids these symptoms should quickly settle. If discomfort lasts more than 24 hours, take a sample of your urine to your GP for testing because it may be a sign of infection.
Some people find a small amount of blood in their urine when they go to the toilet. If this lasts more than 24 hours, you should see your GP because it may be a sign of infection.
After having urodynamic tests there is a small possibility that you may develop a urinary tract infection. This is caused by putting catheters into your bladder during the test. To help reduce the likelihood of developing an infection after the test, your hospital may advise you to:
- Drink extra fluids for 48 hours after the test. This will help you to 'flush' the system through. Aim to drink about two and a half litres a day for the 48 hours after the test (9-10 cups of fluid).
- Cut down on your tea and coffee intake for 48 hours after the test. This will reduce bladder irritation until your bladder returns to normal. Drink water, herbal and fruit teas, juices and squash.
- When you go to the toilet to pass urine, take a bit longer to make sure that your bladder is fully empty. When you have finished passing urine, wait for a couple of seconds and then try again.
Are there any side-effects or complications from a urodynamic test?
Some urodynamic tests involve using X-rays. X-rays should not be used on pregnant women so let your doctor know before the test if you are, or think you could be, pregnant.
Most people have urodynamic tests without any problems. As mentioned above, there is a small chance of developing a urinary tract infection.
Contact your GP if you develop any of the following symptoms:
- A stronger than usual urge to pass urine.
- Your urine smells, is cloudy or has blood in it.
- You want to pass urine more often during the day and night.
- A burning or stinging sensation when you pass urine and feel that you are only passing small amounts at a time.
- Lower backache or pain in your kidneys.
- If you feel hot and develop a high temperature.
|Original Author: Dr Tim Kenny||Current Version: Dr Rachel Hoad-Robson|
|Last Checked: 24/02/2010||Document ID: 12722 Version: 1||© EMIS|
Disclaimer: This article is for information only and should not be used for the diagnosis or treatment of medical conditions. EMIS has used all reasonable care in compiling the information but make no warranty as to its accuracy. Consult a doctor or other health care professional for diagnosis and treatment of medical conditions. For details see our conditions.